Exhibition

Home > Exhibition > Content
Appearance requirements and winding requirements for aluminum-plastic composite tape
Sep 17, 2018

Appearance requirements for aluminum-plastic composite tape

1. The surface of the aluminum-plastic composite tape should be smooth, uniform, free of impurities, no spots and wrinkles.

2. The side of the aluminum-plastic composite tape without slitting is allowed to be protected by a plastic film of 2mm-5mm, and its side should be smooth and free of curling.

3. The side of the slit aluminum-plastic composite strip should be flat and the unevenness is less than 1mm. When it is pulled out, the edge should have no obvious wave.

  

Winding requirements for aluminum-plastic composite tape

1. The aluminum-plastic composite tape should be tightly wound on a steel or equivalently made die. The inner diameter of the die is 100mm±2mm, 150mm±2mm, 204mm±2mm, 406mm±2mm, and the aluminum is cut. The degree of the core of the plastic composite tape should be the same as the width of the aluminum-plastic composite tape, and the end of the core protruding composite tape should be less than 1 m.

2. When used vertically, it should not be straddle.

3. It is not allowed to have 2 or more aluminum-plastic composite tapes wound on the same core tube.https://www.copolymercoatedaluminumtape.com/








Copyright © WUXI SUDA NEW MATERIAL TECHNOLOGY CO.,LTD All Rights Reserved.Tel: +86-510-85189690